Digital Airspeed Sensor – MS4525DO

25.00 $70.00 $

(1 customer review)
PayPal
Visa
Master

Description

Digital Airspeed Sensor with Pitot Tube

This is a digital airspeed sensor kit developed and recommended to use for fixed wing frames and VTOL drones in plane mode. This sensor has a very low offset, a high resolution, and, best of all, does not suffer from the noise induced by long cables in analog sensors. All Holybro Autopilot Flight Controller Boards with either Ardupilot & PX4 are supported.
It can be used for detecting stalls and is most helpful in windy conditions. Airspeed requires additional calibration, it may be hard for new users to properly set it up as it may lead to unprecedented behavior unless used and calibrated correctly.
If you use your favorite ground station (MissionPlanner, QGroundControl, etc.) to test whether or not the sensor is functioning correctly, you should be able to see the sensor response. You should be able to see the sensor measured values change if you blow mildly from a distance into the tube (never blow directly into the tube as you will tear the diaphragm — these kinds of sensors have a very sensitive types of diaphragms) or cover it with your finger.

Digital airspeed sensor

If you have any questions regarding our products, use the Motionew Contact us page to consult our engineering team.

Specifications

Product contents

Digital Air Speed Sensor * 1
GH 4pin 150mm cable *1
Molex 4pin 150mm cable *1
Rubber tubing 400mm *1
Pitot tube *1

Documents

Datasheet

1 review for Digital Airspeed Sensor – MS4525DO

    Mason Stewart
    September 10, 2024
    Ich werde hier wieder einkaufen!
Add a review
Review now to get coupon!

Your email address will not be published. Required fields are marked *

11 + 6 =